The Bacti-cinerator Sterilizer uses infrared heat to sterilize the microorganisms and is characterized by ease of use, simplicity of operation, no open flame, effective prevention of cross-contamination and safety in use. It has been widely used in biological safety cabinets, purification benches, extractor fans, mobile carts and other environments for microbiological experiments. This article will Bacti-cinerator Sterilizer principle, application and is the use of whether it is safe to describe in detail.

Bacti-cinerator Sterilizer Working Principle

Bacti-cinerator sterilizer is an infrared heated inoculation ring sterilizer, which consists of a shell, a ceramic tube, an electric heating wire, a high temperature quartz tube and a temperature controller. The ceramic tube is cylindrical, with one end located on the top or side of the shell and the other end located inside the shell. The two ends of the ceramic tube are equipped with an outer oven cover and an inner oven cover, and a temperature sensor is installed in a small round hole in the inner oven cover. The outside of the ceramic tube is wrapped with an electric heating wire, and the outside of the electric heating wire is wrapped with a mica tape, and the outside of the mica tape is wrapped with high temperature aviation cotton. The furnace tube is equipped with a high-temperature quartz tube to ensure that the sterilization environment is both hygienic and safe.

Bacti-cinerator Sterilizer Operation Procedure

  1. Turn on the power, turn on the switch, and preset the temperature for those with temperature control. Then preheat to the desired temperature or wait until the inner chamber of the sterilizer turns red.
  2. Put the front end of the inoculation ring into the inner cavity, if it turns red, it means the instrument can work normally.
  3. After the experiment is finished, turn off the power of the electric sterilizer.

Bacti-cinerator Sterilizer Maintenance

  1. When using the Bacti-cinerator Sterilizer, be sure to follow the instructions strictly and avoid burns and electric shocks.
  2. When the instrument does not work, the fuse may be blown due to prolonged use, and it is necessary to replace the fuse nearby.
  3. Do not touch the burner to avoid burns, and do not touch the burner immediately after use.
  4. Bacti-cinerator Sterilizer due to long-term use will result in the accumulation of some ash in the inner chamber, need to be cleaned up at the right time.
  5. After the experiment, turn off the power in time.

Is infrared sterilization safe

Yes, you can use the following methods to determine its safety if you still have doubts during use.
Observe the heating body. Heating body is the main component of the infrared sterilizer, heating body failure is caused by one of the main reasons for the decline in sterilization effect, which is mainly manifested as a decline in the speed of warming; second is to affect the heat distribution; third is to produce dust material. The reason is mainly due to the long-term use of the heating body or the poor quality of air through the heater, as well as the purchase of the infrared sterilizer quality itself, whether the heating body failure on the sterilizing effect of good and bad influence.